Posts by Flip_5

Not sure where this should go, I posted in Display Devices (sub $5000)forum, but perhaps here is a better choice... OK, here's my situation... Some of you may remember awhile back I was trying to work around a chandelier hanging from...

OK, here's my situation... Some of you may remember awhile back I was trying to work around a chandelier hanging from the center of my soon to be home theater room...well, I finally took it down and put up my Sanyo Z1. I used the...

I would go with the denon 3803 and use the component switching/upconversion features until you can spring for a good separate amp... this way you can use the 3803 as a pre/pro once you get the amp since the processing capabilities of the...

Not sure what you are asking, but you have a PM. Mike

If you're just passing audio, you should have no problems, however, you need to be careful when passing video over standard CAT 5 (or CAT5e). I thought it would work also, however when I made a "component cable" to run to my...

Anyone?

OK, I'm looking to upgrade my receiver, and I am looking for (if it exists) a receiver that has 2 sets of component out. I would like to have one set hooked up to my TV and one set run to my projector. And it should have a minimum of 3...

Is there a receiver that has 2 outputs for components? I am in the market for a new receiver and looking to keep it under $1000. It needs to have minimum of 3 sets of component in (DVD, DBS, Video Game) and 2 component out: one for my...

Well, I have an appointment set up for tomorrow for installation of iO and HDTV (SA-4200HD I assume) My question is will this box allow me to add an OTA antenna or will I have to get a separate box, or is there a way to put some sort of...

The more I think about it the more I think I will remove my chandelier and use table/floor lanps until I can install sconces. I think a projector would look nice in that round domelike area (what would you call that?) OK maybe not as...