Posts by joshua-s

I appreciate those comments. I do like control 4 and a few others out there, but I have to stick with Crestron on this one. The one item that I am unsure about is the adagio piece. I may just go with another controller from...

Ok so I have a 7000 square foot home and no cabling.......yet. Just looking for advice and thoughts from everyone here. Basic rundown of system: Theater Jvc Pro Projector w/ motorized lens (rs232) Yamaha z7 (rs232) with B...

Most would use a simple 4 flasher setup like xantech, niles, channelvision all offer. Just run one cat 5 from your ir receiver to the closet. I normally use xantech and they have a connecting block that accepts bare wires which you...

I appreciate your help. I have already placed channelvision panels with tele and video distribution in each apartment. Also each unit is prewired for networking if later on the tenant wants that. I just want to make sure it is...

Just wondering if RG-6 at 225 Feet to around 100 Feet for some drops will work perfectly rather than running RG-11 for this installation. This is for an apartment complex of 22 units. My plan was to do a homerun from every apartment...

Just wondering if RG-6 at 225 Feet to around 100 Feet for some drops will work perfectly rather than running RG-11 for this installation. This is for an apartment complex of 22 units. My plan was to do a homerun from every apartment...

I'm looking for someone who has done work with metal studs. I am wiring an apartment complex w/ metal studs and have a few questions. Please send me a pm and I'll get back to you with my questions. Thank you very much. Joshua

Absolutely, we do this all the time. Just make sure your good at terminating.

Any suggestions for mounting a lcd on a fireplace with exposed brick? The brick is from floor to ceiling. I believe there is space behind the brick because the house was built in the 90's. I have installed above fireplaces before,...

Yes volume controls and any low volt cables should be around 18 inches or so. The basic rule is to keep them one bay over. If that is not possible or wouldn't look good you can put it in the same bay but I would suggest running the...