New Posts  All Forums:

Posts by Webomatic

I found a REL T series worked well with Vandys. However the high pass wire configuration on this sub differs with a tube amp, so if you buy a REL just read the specifics when connecting to a valve system.
Kef makes surround systems that would be in your wheel house. http://www.kef.com/us/surroundsound/kht
Quote: Originally Posted by M Code Most AVRs that sell for < $599 have BS power output specs.. If thats your budget then get an AVR with Pre-Outs that way later you can add an out-board component amplifier if you need more watts.. ...
Have you tried setting the AV receiver's speaker configuration to "small"? You'll typically find a setting for large or small speakers in the AV receivers speaker setup configuration. Set it to small and see if that takes care of your...
I would suggest using an array cluster or two suspended if the ceilings are not too low or too high. This would be a cluster of 3 active monitors hanging from the ceiling in an array. The active speaker monitors you'll be looking for...
The BG Radia's are very ear pleasing. The sound array is a little narrow, but overall a great sounding planar speaker. Take a listen to the NHT iC4 speakers. The audio quality for the dollar is hard to...
Quote: Originally Posted by Chu Gai Out of nothing more than simple curiosity, was it the speakers that struggled or was it a lack of sufficient power? I was thinking the same thing reading this thread. An amps bias plays an...
The speakers should last. As for your ability to hear, that all depends on your level of satisifaction. I would still give the AudioEngine speakers a listen. I'm sure you will be satisfied by what you will hear from these little...
An amplifier is like your stereo receiver. In this case the power to drive the speakers are built into the speaker. You should be able to find a local retailer who sells them. Maybe an Apple store in your area, best buy may have them,...
Samsung has been known for putting its money into the picture display and not the speakers that's for sure. You didn't specify what you were going to use for an amplifier so I have an all-in-one solution you may want to find at your...
New Posts  All Forums: