Posts by jdsmoothie

On the front panel (see below), press the INPUT MODE button until the front panel display reads "Auto".

First note that the LPF for LFE default setting of 120Hz only applies to the LFE (0.1) signal and not to any signals passed to the individual speakers, rather the speaker crossover settings determine what frequencies pass to the sub. ...

1. Reset the speakers to LARGE and sub to LFE+Main. 2. http://www.avsforum.com/t/1334369/the-official-denon-avr-xx12-model-owners-thread/0_100#user_L1

What isn't happening to make you believe it's not in standby mode? The power ring will only turn "red" in Standby when either HDMI Control or Network Standby is set to ON, otherwise it will remain off even though the unit is still in...

The following post may apply .... http://www.avsforum.com/t/1465528/the-official-2013-denon-e-series-x-series-avr-model-owners-thread-faq/0_100#user_L29

Sure. Reset the AVR (p. 146 OM).

Try resetting the xBox while connected to the AVR.

Make sure the "Amp Assign" setting (p. 80 OM) is set to "Normal" and not "Zone 2". With the Zone 2 pre-outs of the 7005 connected to the external amp, note that only PCM 2.0 over optical/digital coax or analog 2.0 sources will pass to...

With the component video cable (red/green/blue) connected to the 1913 using the default input of CBL/SAT, you cannot have any HDMI input connected to the HDMI(CBL/SAT) input so you may want to "assign" that input to another source name...

6006 can pass PCM 2.0 audio over optical/digital coax to Zone 2 but cannot play Airplay independently to Zone 2 with another source playing in the main zone. While the reverse is true for the 6007 (ie. cannot do PCM 2.0 to Zone 2 but...