Posts by smoke90

raaahhh I missed it This is a good point I should have cut it after the assembly. Especially to be sure they are concentric Dan I saw the time you were posting. 4.02 am. do you ever sleep?

Ok I look at the print I had printed before starting it says 12 1/8"???? I just look at the page 1 it says 11 5/8. so yes you have changed it. I printed it 3/6/09 I can scan my print if you like. I want a full bag of cookies

As any of you watch a movie on BR and then through the stream to see the difference if any? I wanted to try it with the PS3

Quote: Originally Posted by NEO Dan Smoke, you only need a HandyPanel, it's a 2'x4' piece ask for it at HomeDepot you probably won't need a truck either, unless you drive a Smart I don't think I've made any changes to the front of...

you are right then I will have done something wrong. My hole are not concentric? The hole on IB1 is centered. Have you changed the position of the hole in the front when you updated the dimension last week? I will look at it tonight...

Dan, The IB1 went from 23 3/4 to 21 3/4 but the hole is not center. It has to be 11 3/8" from the top

Dan, when I will do the round over of 1.25" for the internal box (3 corners). I will have a gap connecting the three channel (2.5" spacer) together at the 3 corners. did you planed for that? should I plug those holes with 9 small...

last night I positioned one of the spacer one inch offset. I realized that 10 mn after. it was not easy to remove. It was already quite strong. I am a big fan of glue + screw with pre-drill. Even I do not use them screw where I will...

Quote: Originally Posted by NEO Dan Grrr. I see it. This is what happens when you have to push and pull dimensions figure out a box. I'll fix it. No more cookies for you! no more cookie then no more excuses for error I read the...

I will have another cookie the spacer just under P1 are not 21 but 20"