or Connect
New Posts  All Forums:

Posts by vvilliamm

out of curiosity in the future could i hook up a pair of audioengine a2 to my receiver? then put 2 of my satellites as my rear for 7.1 surround
planning to buy these http://www.staples.com/3M-Command-Ad...ropdown_396131' to mount my speakers without drilling since my landlord doesnt allow drilling
well at least down the road!! i could get two front bookshelf speakers and put my front 2 into my rear back rear right then that will be FULL 7.1 !!! but um for future purposes.. any recommendations?
so um these speakers are pretty good yea?
sorry lol i had to restart my comp and the sound works i get full 5.1 surround in dts but everything else cant pick up the signals now waiting for analog wires to come!
well it picked up the spif 96 digital and sound works now after restarted comp! awesome!
http://mediacdn.shopatron.com/media/...pdf?1288063778 .. atm!!! EPIC TIME!
thanks only got 80-100-150-200 so.. 150 it is lol. well im going to read the manual a bit more to amke sure by default its 8ohms pluggin in speakers!!!!
yep lol i actually have the book reading it croosover freq is 80 by default< in the pioneer it says "Crossover Network • Default setting: 80Hz" so.. crossover network is freq right? i set it to 150 as said by the manul in my klipsch hd 500 "NOTE: The A/V receiver/surround sound processor must be set to “Subwoofer On” and all speakers set to “small”. The suggested crossover point is 150 Hz. If 150 Hz is not available, use 120 Hz." i dont have the mic yet but i want...
well atm im wiping it to factory stock and following the manual of my speakers to get it set properly before plugging it "NOTE: The A/V receiver/surround sound processor must be set to “Subwoofer On” and all speakers set to “small”. The suggested crossover point is 150 Hz. If 150 Hz is not available, use 120 Hz."
New Posts  All Forums: