Posts by mtg90

Or drill a small hole in the back where you are going to mount them just large enough to fish the wire through then apply just enough hot glue to seal the hole. You could even use masking tape to seal it up by using two pieces applied...

I think they look great!

All the info for both of these designs including the TD15M-4 + DNA-360/SEOS-12 design can now be found in the DIY Sound Group forums under the SEOS Speaker Designs category.

That's the crossover cost for the LCR and height's. The inductors where not the big killer for cost, the Jantzen P-cores only cost $2-3 more then the Erse I-cores. The big caps on the woofers circuit are what really ate up a chunk of...

What's this I hear now?

Quote:Originally Posted by bass addict I swear if you peeled back Matts skin, you would find a cyborg underneath. Skin? You mean my protective MDF coating

Individual driver frequency responses with crossover, 4550: DNA-360: Both overlaid:

Oh and look what showed up today, 14lbs of crossover parts! I am going to get busy.

Tux here is your requested graph: Mark, the shapes of the 4550 and DNA-360 low corners are very close. I don't have graphs of just the HF driver saved for the latest crossovers so I'll see if I can get them measured. Travis just wait...

Quote:Originally Posted by bhazard I think it would be on a per woofer basis. Some may sound better being crossed over lower, while with others it won't make a difference. Isn't the crossover point on the SEOS15 (850hz) the lowest...