New Posts  All Forums:

Posts by rhinomike

Quote: Originally Posted by dr_hsu THX Ref means that is the level the movie is supposed to be played back at to sound the way the producer wanted it, and suppose to re-create what you will hear at a THX theater. But if you want to...
Quote: Originally Posted by dr_hsu Did you run Audyssey with the sub at 10 o'clock, and Audyssey set the sub out at -3? If Audyssey calibration was done with subwoofer volume at 8 o'clock and it sets the sub out at -3, and then you...
Oh yeah. The volume is normally at 82. Is that ok? That is where my installer told it should be. It reads THX Ref at 82. Whatever that means. Lol.
Quote: Originally Posted by dr_hsu I would set the crossover at 80 Hz for all speakers. That means you want bass to be maybe 10 dB higher than flat! If you leave the sub volume at 8 o'clock, how high do you have to set the subout on...
Quote: Originally Posted by dr_hsu I would set the crossover at 80 Hz for all speakers. That means you want bass to be maybe 10 dB higher than flat! If you leave the sub volume at 8 o'clock, how high do you have to set the subout on...
Quote: Originally Posted by JChin Hi rhinomike,you should find this setting under "Speaker Configuration" at the Speaker Setup menu. Thank u. I am going to give it a try again here in a few minutes. I pushed menu on my remote and got...
Quote: Originally Posted by dr_hsu I would set the crossover at 80 Hz for all speakers. That means you want bass to be maybe 10 dB higher than flat! If you leave the sub volume at 8 o'clock, how high do you have to set the subout on...
Quote: Originally Posted by dr_hsu You should set the crossover on the sub to 'out'. With the crossover set to out, the frequency setting does not matter. Leave the crossover at out after calibration as well. The crossover on the...
Quote: Originally Posted by dr_hsu Did you re-run Audyssey auto calibration? Remember to set the sub to one port open, EQ1, Q=0.7 for the Audyssey calibration. After calibration, set to two port open, EQ2, Q=0.3. Bass level should be...
Quote: Originally Posted by dr_hsu Remember, set the sub to one port open, EQ1, Q=0.7, volume 9 o'clock, phase 0, crossover out. Run Audyssey auto calibration with mike at your listening position. After calibration, check receiver's...
New Posts  All Forums: