Originally Posted by jayjay72
Ok I have the Pioneer sc-07 and I know very little about it but
it awesome after the auto calibration with blueray and pioneer plasma kuro.
I have a 7.1 setup in the living room.
I have another amp jvc 5.1 I want to use for the garage and outside.
It has speaker system 1 and 2 or 1 & 2 together with the press of a button
Well The sc07 is getting internet radio and I want to send the signal to
the other jvc amp. I have tried on the zone out and zone 3 out optical
with no luck. I also tried with the regular audio out from zone 2 and 3
with no luck. Read the instructions and still stuck...
I cheated and got it to work using the front out on the sco7
but when I use the volume up and down on it changes on both amps.
I just want the signal out to the 2nd amp...
If anyone understands this madness and is knows the sc-07 please help!
HOME MEDIA GALLERY, XM and SIRIUS cannot be selected for
You probably want to hook up from the zone 2 of the SC-07 to your other receiver's input (analog IN/OUT).
(very similar to how you hooked it up from the front panel, only using the zone2 outputs.)
page 66 has good info on multi-zone connections and pages 68 and 69 show how to control mult-zone with either the front panel or the remote.
For volume, you want to set it as fixed, so you can control it from your JVC.
see page 95:Fixed
– Use this setting if you’ve connected a fully
integrated amplifier (such as another Pioneer VSX
receiver) in the sub room and want to use that
receiver’s volume controls.
With the Fixed setting, the source is sent from this
receiver at maximum volume, so make sure the volume is
quite low in the sub zone at first, and then experiment to
find the correct level.
Other than that, you may want to look at mhdiab's setup here:http://www.avsforum.com/avs-vb/showt...8#post17899698
I'm sure he can tell you all kinds of tricks he learned the hard way.. good luck!
Hope that helps.