Recently installed a HDMI cable on my BH 200 hooked up to my Epson 1080UB. I sometimes get a flickering(blinking) of the image upon start up of my system. It can occur before the movie even starts to load. The HDMI cable is directly connected to the PJ so there is no switching device between the PJ and the BH 200. I guess it is some kind of handshake problem between the two devices. I can get around the problem by shutting off the BH 200 and turning it back on again. Any suggestions to cure this problem would be most appreciated. BTW, I experienced no problems when I ran the system on component.
post #1 of 4
10/10/08 at 8:18am