AVS › AVS Forum › Display Devices › Plasma Flat Panel Displays › TH PF series PIP rs232
New Posts  All Forums:Forum Nav:

TH PF series PIP rs232

post #1 of 4
12/26/08 at 5:18pm
Thread Starter 
Anyone have luck swapping the pip Sub picture Input Select ISS:***(*)

Currently sending \\x02ISS:PC1\\x03

I can move the picture but does not seem to like the sub picture select command

All other commands seem to function...

Thanks
Reply
Reply

AVS Top Picks

post #2 of 4
12/26/08 at 9:38pm
ISS:xxx is the correct command so it should work.

Note that PIP cannot be two analog signals (ex:PC-component), one of the inputs must be digital. analog-analog combinations are invalid.
See attached.

T Wiz

 

PEE-P021-R2_PIP.pdf 189.119140625k . file
Reply
Reply
post #3 of 4
12/27/08 at 5:10am
Thread Starter 
Yup.... lol figured I would stop spinning my wheels.. last line of page 20 HA! thanks for the pdf!
Reply
Reply
post #4 of 4
12/27/08 at 7:01am
In these cases, composite is considered a "digital" input if that helps.

Component, RGB, and PC (VGA) are analog signals.

HDMI, SDI, DVI, and composite noted above are digital inputs.

For dual input boards (TY-FB10HMD; HDMI and TY-FB9BD; composite) you may use only one of the dual inputs at a time. In other words you cannot use both inputs of a dual input board as both imputs of PIP.

TW
Reply
Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Plasma Flat Panel Displays

AVS Top Picks

AVS › AVS Forum › Display Devices › Plasma Flat Panel Displays › TH PF series PIP rs232