AVS › AVS Forum › Display Devices › Rear Projection Units › Mitsubishi WD-57731 infrared(remote) function is not working
New Posts  All Forums:Forum Nav:

Mitsubishi WD-57731 infrared(remote) function is not working

post #1 of 4
Thread Starter 
Mitsubishi WD-57731 infrared(remote) function is not working, I've tried the Dish Network remote and the WD-57731(Week 25, Year 2006) TV remote and I even put new AA batteries into the 57731 TVs remote and I can only turn the TV on and off or raise and lower the volume at the TV, The remotes work, I think the TVs infrared function is dead as It did this once before and then came back, But so far not this time, I even tried resetting the TV, No luck.

The Closest repair place is Russells VCR & TV Repair in Barstow CA(Not authorized last I looked by Mits, But the TV is not under their stupid warranty, I just hope He can order the parts needed), Most authorized Mitsubishi repair places want Me to bring the 57" TV to them as their about 38 to 50 miles away and for Me that's impossible as It requires a van and I don't have that and My Car sure won't hold such a big TV, Don't places come out to do service on Big TVs?

I almost feel like tossing the remote at the TV.......
post #2 of 4
did you reset the remote?
I believe it is: press and hold power button until it blinks 2x then enter 00935

if for some reason the IR sensor is not working (although since it does some functions I dont think it is any problem with the TV) you can replace the sensor quite easily and I think they are a common electronic part.
post #3 of 4
Thread Starter 
Tried that on the Mits TV remote, The Dish Network remote I tried all the Blue Button codes and the TV does not respond, The Dish Box does, Just not the TV.
post #4 of 4
why would the TV respond to the dish network remote? Does it have some function to output mitsubishi codes?
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Rear Projection Units
AVS › AVS Forum › Display Devices › Rear Projection Units › Mitsubishi WD-57731 infrared(remote) function is not working