AVS › AVS Forum › Display Devices › CRT Projectors › Powerstrip settings for BARCO 1209s - 1080p
New Posts  All Forums:Forum Nav:

Powerstrip settings for BARCO 1209s - 1080p

post #1 of 7
7/27/09 at 10:31am
Thread Starter 
Hey!

I use a HTPC with powerstrip to view 1080p on my BARCO 1209s.
What are the best setting of powerstrip for 1080p?

I use 1920 x 1080 @ 72 Hz (picture below) but sometimes I have problems with the stability.

Sometimes the BARCO goes to bank 4, but there the bank is empty.
I think it could be a problem with powerstrip...

Thanks for help!
LL
Reply
Reply

AVS Top Picks

post #2 of 7
7/27/09 at 2:32pm
Search out the VESA GTF spreadsheet. (This should have been a sticky 10 years ago, but I've never seen this mentioned anywhere on AVS.)
Reply
Reply
post #3 of 7
7/27/09 at 2:41pm
Add more back porch pixels, it sounds like you are on the border of two memory blocks in the barco.

Get it a bit further away from 80khz.
Reply
Reply
post #4 of 7
7/29/09 at 11:19am
Thread Starter 
@ Mark_A_W: thank you for your advice! Now I have modified my powerstrip setting to 79,914 kHz. Is that right?

I will try this the next days...
LL
Reply
Reply
post #5 of 7
8/24/09 at 12:05am
Thread Starter 
It works for few weeks, but now I have the same problem again!!!!
My powerstrip setting is still at 79,914 kHz.

But my BARCO select always a empty memory bank...

Has anybody a idea?
Pleas help me...
Reply
Reply
post #6 of 7
8/24/09 at 12:59am
I would try to chance vertical sync to negative.

Also 71.928 Hz vertical refresh rate could give smoother pans.
Reply
Reply
post #7 of 7
8/24/09 at 2:32pm
Yes, that is a coincidence.

Is that 79.914 Khz scanrate? Or 79.914hz vertical refresh rate?
Reply
Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: CRT Projectors

AVS Top Picks

AVS › AVS Forum › Display Devices › CRT Projectors › Powerstrip settings for BARCO 1209s - 1080p