yes the (2) pairs of speakers were hooked up to and running from the Main Zone, but this was running the 2311ci very hot to the point of it turning off a few times during use. I assumed the Zone 2 config was the only way to run an external amp to take the load off of the 2311ci as an amp and have it only serve as the controller. After hooking it up and trying to get the signal to pass through, I finally read in the owner's manual about not being able to run digital audio signals out through Zone 2, this is why I am wondering if there's another setup config that I can try with the amp? The amp separate is a Parasound Model 2125.
post #4891 of 5012
7/15/13 at 2:13pm