Proper configuration is:
3D Source Device INTO GEFEN INTO 3DA-1 INTO Samsung 3D DLP HDMI #3
Proper multi-source configuration:
3D Sources INTO HDMI 1.3 switch INTO Gefen INTO 3DA-1 INTO Samsung 3D DLP HDMI #3.
To clear up many mis-conceptions about the 3D TV Adapter, it's evolution and final release:
We DO NOT use the GEFEN to spoof the Mitsubishi Adapter, this was only done during our first 60 days of sales to gathter market real-world usage data with the various firmware updates occuring accross platforms this summer. We have offered a free update to all TRU3D customers to re-configure the adapter into a plug-and-play final solution.
We DO re-configure the Mitsubishi Adapter (3DA-1 or 3DC-1000) to be directly connected to the Samsung DLP HDMI #3. IE only a HDMI 1.3 cable.
We DO use the GEFEN on the input side of the Mitsubishi Adapter (in between the 3D sources and Mitsubishi Adapter) in order to communicate all 3D modes, supported plug-and-play ID and Samsung DLP compatible 3D HD scan modes to the 3D Playback device.
The 3DA-1 will not turn on unless connected to both a valid source and a television. Do not think your 3DA-1 is DOA if it does not turn-on with only the power supply connected.
Do not use a gefen on the output side of the 3DA-1. Spoofing the 3DA-1 with a Gefen using Mitsubishi EDID to enable 3D functionality will give you very limited results and cause the need for complex work-arounds with many devices. The 3DA-1 must be re-configured for direct connection to your samsung.
You must have a Gefen on the INPUT side of the 3DA-1 to signal the 3D playback source. The 3DA-1 does not properly send HDMI 1.4 data to playback sources when connected to a Samsung DLP and a 240Hz compatible GEFEN with custom data must be used for this purpose when the 3DA-1 is direct connected to the Samsung DLP.
If you direct connect your Samsung DLP to a Mitsubishi Factory shipped 3DA-1 that was not purchased from TRU3D, it will not work. The power will come on, but the 3D modes will not operate. You must ship it to us to be re-configured for direct connection.
Writing data to the 3DA-1 will cause malfunction and damage your 3D DLP.
Writing data to your samsung will cause malfunction and damage your 3D DLP.
There is no Firmware update available to improve Samsung 3D DLP operation, do-it-yourselfer's data is erroneous, it will both shorten the lifespand and reduce compatibility of your Samsung 3D DLP.
If you did not buy your Gefen + 3DA-1 from TRU3D, you may ship them to TRU3D be programmed and configured for a $75 fee.