I'm hoping you can give me some pointers how to get my HTPC<->receiver setup working the way it should. My goal is to use HTPC to send on/off signals to receiver via RS-232 when suspending/resuming. Additionally I'd like to query receivers current input and if needed, switch to proper HDMI.
Some info: I've connected my Mythtv-running Ubuntu-based HTPC to Sony STR-DE3500ES AV-receiver using null-modem (female-female) serial cable. Serial interface is Zotac ION MB's one. Receiver is set up to use serial port (installer mode or something like that it was called) and I can see some sort of communication going on as I run minicom/cutecom from HTPC and switch receiver on and off.
Minicom is set up to use proper settings (9600 baud, 8N1) but all the info coming from the receiver and shown on the minicom screen is garbled (binary?). Cutecom shows proper ascii (ie. a8 82 00 1a 22 21 00 72) when switching the receiver on and off. I've tried echoing some of the Sony-specific commands found here to /dev/ttyS0 using shell, minicom and cutecom but receiver doesn't react to those in any way. I've tried to figure stty out to setup the serial interface to correct settings, but without any luck so far. Only way to see any communication actually happening is to use minicom/cutecom and toggle with power on/off.
Any tips how to debug this one?
Some info: I've connected my Mythtv-running Ubuntu-based HTPC to Sony STR-DE3500ES AV-receiver using null-modem (female-female) serial cable. Serial interface is Zotac ION MB's one. Receiver is set up to use serial port (installer mode or something like that it was called) and I can see some sort of communication going on as I run minicom/cutecom from HTPC and switch receiver on and off.
Minicom is set up to use proper settings (9600 baud, 8N1) but all the info coming from the receiver and shown on the minicom screen is garbled (binary?). Cutecom shows proper ascii (ie. a8 82 00 1a 22 21 00 72) when switching the receiver on and off. I've tried echoing some of the Sony-specific commands found here to /dev/ttyS0 using shell, minicom and cutecom but receiver doesn't react to those in any way. I've tried to figure stty out to setup the serial interface to correct settings, but without any luck so far. Only way to see any communication actually happening is to use minicom/cutecom and toggle with power on/off.
Any tips how to debug this one?
