Have had the pro1 about a week and like it very much! I can say LCOS is much better looking then LCD technology, if anyone is still debating between the two.
I have a question. I have calibrated the Pro1 using the following review as a guide:
The problem I am having is setting the last section, here is a copy of it below:
Calibration settings for User: Iris off, all other settings same as pre-calibration or as stated below.
User 3, Custom 3, Gamma 3 Quick Cal, User 1, Custom 4
Gain R = 8 R = 20
G = 0 G = -10
B = -9 B = -25
Bias R = 5 R = 0
G = 0 G = 0
B = -3 B = 0
Lumens at 100 IRE: 768 @ 6794 982 @ 8167
This picture look much better after calibration, and it fixed the problem I was having with the blacks. The blacks are much better now.
I can't figure out how to adjust gain on the RGB channels however like it says at the bottom of the review. Anyone know where the settings are on the Pro1 to adjust this? How do i get R=8, G=0, etc?