AVS › AVS Forum › HDTV › HDTV Recorders › Pace RNG150n & atlas 1056 remote program ?
New Posts  All Forums:Forum Nav:

Pace RNG150n & atlas 1056 remote program ?

post #1 of 5
4/13/11 at 10:50am
Thread Starter 
I just got installed today the Multi Room DVR with RNG150N and DC900x Pace equipment.

I am trying to program the 30 sceond skip into the new remotes and everything I have tried hasn't worked. Is there something special I must do to get this to program?

Another question is have they activated the eSATA port to add an additional harddrive to this setup? The software version is 78.73 and the provider is Armstrong Cable.

Thanks in advance for the help!
Reply
Reply

AVS Top Picks

post #2 of 5
4/16/11 at 7:37pm
Thread Starter 
Anyone?

Nobody has any info about this....
Reply
Reply
post #3 of 5
5/8/11 at 5:26pm
Very Interested in this as well.
I have the same model box (Pace RNG150N 'Denali'), but from Insight Cable out of Louisville, Ky.

>>I am Looking for remote codes for a 30 Sec FWD/15 Sec Back skip feature similar to my old Motorola DCT Series Unit<<
Awayne, Have you found the answer yet?
Has anyone reading this forum found a solution?
I wonder if the Pace unit even has the capability?
Reply
Reply
post #4 of 5
5/11/11 at 11:57am
I found my solution.
The Insight remote for my old Moto DCX and the Pace RNG was similar enough that the same programming codes worked, and as it turns out the Pace box has the same skip capability.

Pulled from this site.

Quote:


1. Press the "Cable" button at the top of the remote to put it into Cable Box control mode.
2. Press and hold the "Setup" button until the "Cable" button blinks twice.
3. Type in the code 994. The "Cable" button will blink twice.
4. Press (do not hold) the "Setup" button.
5. Type in the code 00173.
6. Press whatever button you want to map the 30-second skip command to (ex: PIP CH +/-). The "Cable" button will blink twice if successful.
Reply
Reply
post #5 of 5
6/13/11 at 10:30am
Armstrong is now using a 1056B03 (old ones were 1056B01) - Armstrong informed me that the 1056B03 will not accept the 994 programming to reassign a key to the skip - My old 1056B01 was programmed with the skip and it works on the RNG150N/DC900X installed in my home so that proves that the PACE supports the SKIP.
Reply
Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: HDTV Recorders

AVS Top Picks

AVS › AVS Forum › HDTV › HDTV Recorders › Pace RNG150n & atlas 1056 remote program ?