Volume Memory feature??

Subscribe Search This Thread

Start a New Thread

post #1 of 5

6/1/11 at 8:55am

Thread Starter

2 Posts. Joined 7/2010
Select All Posts By This User

I am looking to get a receiver with the ability to return to a specific volume level for each input when switching between sources.

I see several receivers support an initial volume level setting but the ones I have found this only applies to powering up the receiver to an initial volume. I have also seen receivers with the ability to adjust each input with a volume offset allowing consistent audio level between different sources.

I would like information on receivers or companies that support either an initial volume setting per input or possibly just a feature that returns the volume to the last volume level used for a given input.

Thank you for any help.

post #2 of 5

6/1/11 at 9:44am

18,238 Posts. Joined 11/2006
Location: Colorado Springs, CO
Select All Posts By This User

I believe my last 3 Yamaha receivers had both an initial volume setting, a max volume setting, and a level trim for each channel. They were/are all expensive models, but they may have the same features on cheaper models.

post #3 of 5

6/1/11 at 10:57am

M Code
Trader Feedback: 0
Roto Rooter Spin Tech
offline

9,033 Posts. Joined 3/2003
Location: Lake Piru, CA
Select All Posts By This User

Those are very common software features..
But you better check the target AVR brand/model before purchasing to verify these are implemented..

Just my $0.02..