I have a few questions about getting started with Demopad/IP control.
I have a Denon 4308 that I want to control over IP.
I am able to get the buttons to show up on my iPad.
However, I cannot get the Denon to respond.
I confirmed the Denon works over IP via the Web Gui.
I created the device (Denon AVR4308), used the same IP as the GUI. How does one determine the correct port?
To start with I chose to create a button for Vol Up,
Attached is the screen shot
Is this setup correct?
Nothing happens in the AVR when the button is pressed.
Is there any way to confirm that Demopad is communicating with the AVR?
Port = 23 (as noted in the Denon RS232 protocol PDF: http://usa.denon.com/us/Downloads/Pa..._Ver5.1.0a.pdf
Once I changed the Command Suffix to \\x0D it the AVR responded.