the wides were tricky to put in. Apparently we messed up something in the model and the speaker does not fit at the desired angle. I wanted it aimed behind my head in the center position but its more aimed directly at me or slightly in front of me. Also, to have it at the correct height I needed to build a shelf thats even with the bottom of the column insert. This is the only speaker on a shelf because of the required angle.
I started the way I normally do with boards that allow the insert to slide into place.
I then cut a shelf that goes on top of that for the speaker. The final design had the shelf slightly elevated so it does not catch on the speaker when inserting it
I then build the bottom of the column insert to fit
with the speaker on it
the three layers of the insert are built. Again, ill need to use a dowel for the side where the speaker points
With the other sides built onto it
with the speaker in and 3 of 4 legs, the open spot is for the dowel
and repeat on the other side
and add the foam to the front right. Now the only places left needing treatment are around the HVAC unit, and on the non existent door. Plus in the end the ceiling