Have not modeled yet. JL suggest:
This potent driver is best used with amplifier power in the 400W - 1000W range and is optimized to operate in a 1.375 cu. ft. (38.9 l) sealed enclosure, or a 1.75 cu. ft. (49.6 l) ported enclosure.
I was thinking a bit bigger. ...and these are not set in stone I'm looking into other drivers aswell. less $$$ w/similar ratings. IMO JL makes some good drivers.
What would be optimal cu ft ? sealed or ported? I started out with this idea for boxes to set my rear towers on to raise them up about 1.5ft and got the bright idea to add subs
as i said I'm no pro this might be a stupid idea.
PS. Reason for the 1000w = so that i don't clip these subs because of the expense involved. I want enough available power so is not to strain either amp or sub.
Free Air Resonance (Fs)
Electrical “Q” (Qes)
Mechanical “Q” (Qms)
Total Speaker “Q” (Qts)
Equivalent Compliance (Vas)
2.33 cu ft / 66.0 L
One-Way Linear Excursion (Xmax)*
1.15 in / 29 mm
Reference Efficiency (no)
Efficiency (1 W / 1 m)**
86.2 dB SPL
Effective Piston Area (Sd)
84 sq in / 0.0542 sq m
DC Resistance (Re)