or Connect
AVS › AVS Forum › Display Devices › Display Calibration › Calibrating for two sources - BRay and Directv. Two calibrations or just one?
New Posts  All Forums:Forum Nav:

Calibrating for two sources - BRay and Directv. Two calibrations or just one?

post #1 of 3
Thread Starter 
When I last had my SharpVision MKII projector calibrated it was done by an ISF professional who used his calibration disk on my BR player. I assumed this would be very accurate for BR movies but always wondered if it was accurate for my Directv signal. Are the two incoming signals technically different so that two separate calibrations are needed or are they close enough so that only one calibration is necessary?
post #2 of 3
Just one.

DirecTV should be using the same standards as blu-ray.
post #3 of 3
As far as I know, the compression used by the TV signals can make things look a little different, but that's at the fault of the video feed, not your TV calibration. Just one.
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Display Calibration
AVS › AVS Forum › Display Devices › Display Calibration › Calibrating for two sources - BRay and Directv. Two calibrations or just one?