AVS › AVS Forum › Display Devices › CRT Projectors › ECP 4001 Green wont project??
New Posts  All Forums:Forum Nav:

ECP 4001 Green wont project??

post #1 of 5
11/5/12 at 6:48pm
Thread Starter 
Hello, I recently got this projector and everything seems to be fine, all the colors work in the menues but when I hook it up to me computer the green tube does not project the image??? any help please! edit-4101
Edited by Theodore7 - 11/5/12 at 7:51pm
Reply
Reply
post #2 of 5
11/6/12 at 7:11am
Your RGB input board may be bad, but I'd suspect your input cable. REverse the green and red BNC cables and make sure your green cable works. I've got lots of RGB input cards if you need another one.
Reply
Reply
post #3 of 5
11/6/12 at 9:53am
Thread Starter 
I got it, the connection if the green bnc cord has a little play. That was it, took me hours to figure it out. But so worth it. Thank you Curt!
Reply
Reply
post #4 of 5
11/7/12 at 5:49pm
Thread Starter 
I've run into another problem.. The center of the green gun will no focus, The direct center will but I little bit up and it refuses, no matter what I do. Is this a resistor issue on the Focus board?
Reply
Reply
post #5 of 5
11/8/12 at 7:54am
No, it sounds like you most likely have fungus. There is one global focus control per tube. If the edges are in focus, the centre should be as well. Fungus however will make it look like it's a mile out:

http://curtpalme.com/Fungus_Removal1.shtm
Reply
Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: CRT Projectors
AVS › AVS Forum › Display Devices › CRT Projectors › ECP 4001 Green wont project??