AVS › AVS Forum › Audio › Receivers, Amps, and Processors › Standby Sync / Yamaha RX-V773
New Posts  All Forums:Forum Nav:

Standby Sync / Yamaha RX-V773

post #1 of 5
11/28/12 at 3:22am
Thread Starter 
Hi,

i use my iPad as a universal remote trough DLNA to turn on my receiver and then receiver turns on my TV (Sony EX-720) trough HDMI CEC (Bravia Sync). My TV supports automatic turn on and off by HDMI CEC but not by DLNA so it's have to be done by receiver but now it starting to look that Yamaha sends standby command only to HDMI IN not to HDMI OUT where's my TV is connected.

Is there any workaround to get this work without IR Blaster?
Reply
Reply

Gear mentioned in this thread:

post #2 of 5
11/28/12 at 9:48am
I don't understand what the problem is--the last part doesn't make sense. How does the Yamaha turn the TV on if it doesn't send signals through the HDMI OUT?
Reply
Reply
post #3 of 5
11/28/12 at 10:03am
Thread Starter 
I meant with standby the power off signal. Power on signal gets to TV by HDMI OUT.
Reply
Reply
post #4 of 5
11/28/12 at 10:35am
I don't believe the Yamaha receiver will ever broadcast the HDMI CEC System Standby message. It won't however stop a standby message from being broadcast up or down the CEC network.

System Standby messages are normally only broadcast by the TV.
Reply
Reply
post #5 of 5
11/28/12 at 11:38am
Thread Starter 
Yeah. Figured out that too. My TV doesn't support power off trough hdmi it was just a translation error because propertys name was in finnish like "automatic device shutdown" and i thought it was referring to a TV but when i changed TV's language to english i saw that it was "devices".
Reply
Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Receivers, Amps, and Processors

Gear mentioned in this thread:

AVS › AVS Forum › Audio › Receivers, Amps, and Processors › Standby Sync / Yamaha RX-V773