AVS › AVS Forum › Display Devices › CRT Projectors › Electrohome ecp Green tube too bright, connection problem?
New Posts  All Forums:Forum Nav:

Electrohome ecp Green tube too bright, connection problem?

post #1 of 6
12/19/12 at 1:12pm
Thread Starter 
hello,
Ok, so when I plug my connections in the green tube does not show, so I wiggle the connection a little bit, give it a few twists and then If I get it in the right position the tube displays the image, but its so bright the whole picture looks green?? ugh! Any ideas? Thank you -Jacob


/
Reply
Reply

AVS Top Picks

post #2 of 6
12/20/12 at 7:11am
We need more info. What input are you using, and what signal source are you feeding to the set? What model ECP is it?
Reply
Reply
post #3 of 6
12/24/12 at 3:08pm
Thread Starter 
ECP-4101 Im using a vga to rgbhv. Signal, I have been using various resolutions at 60hz
Reply
Reply
post #4 of 6
12/24/12 at 8:00pm
What happens in test pattern mode? Is the green too bright then?
Reply
Reply
post #5 of 6
12/24/12 at 8:10pm
Thread Starter 
No, its fine. Looks good.
Reply
Reply
post #6 of 6
12/25/12 at 5:52am
Sounds like a bad video input board. I'm assuming your computer is outputting RGBHV and not component? You're describing exactly what happens when you feed a component signal to an RGBHV input.

I've got spare RGBHV cards at $10 each plus shipping.
Reply
Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: CRT Projectors

AVS Top Picks

AVS › AVS Forum › Display Devices › CRT Projectors › Electrohome ecp Green tube too bright, connection problem?