AVS › AVS Forum › Audio › DIY Speakers and Subs › How bad is it to run different types of drivers off of one channel?
New Posts  All Forums:Forum Nav:

How bad is it to run different types of drivers off of one channel?

post #1 of 2
1/1/13 at 6:46pm
Thread Starter 
I have 3 cabinets with 2xMFW-15 drivers in them, then i have one cabinet with a 15" titanic

I have an ashly klr4000 and an inuke nu3000

Ideally i want to sell the nu3000 since its new in box, and was wondering how you guys would wire my subs up if i was just using the ashly klr4000?

3 of my dual opposed MFW-15 cabinets one channel? 15" titanic on the other?

2 dual opposed one channel, 15"+ dual opposed on the other?

titanic is 4ohm, each MFW-15 is 4 ohm.
Reply
Reply

AVS Top Picks

post #2 of 2
1/2/13 at 9:52am
You didn't mention how the DO cabs are wired.

You could series wire the mfw dual opposed cabs to present an 8 ohm load / cab to the amp. Then you could put 3 mfw cabs in parallel on one channel and the titanic on the other channel. You would then have to adjust the gain lower for the titanic's channel. Maybe -4 to -6db.
Reply
Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: DIY Speakers and Subs

AVS Top Picks

AVS › AVS Forum › Audio › DIY Speakers and Subs › How bad is it to run different types of drivers off of one channel?