AVS › AVS Forum › Audio › Speakers › CSW T300 with 2 bad amps
New Posts  All Forums:Forum Nav:

CSW T300 with 2 bad amps

post #1 of 2
1/20/13 at 6:17am
Thread Starter 
Hi,
I have a pair or CSW T300 speaker and they both have bad amp. I have to have one of the amps reworked by CSW a couple of years ago for $75. I don't want to have to go through this all over again so does anyone know what the known failure or have a schematic for these amps? Or has anyone tried to bypass the internal amps and use an external amp?
Reply
Reply

AVS Top Picks

post #2 of 2
1/20/13 at 7:21am
The amplifier powers the built-in subwoofer on those??

If that is the case, you could just completely disconnect the subwoofer section and get a separate powered subwoofer.

Just connect the full-range input terminals of the speaker to your amplifier / receiver, but disconnect the input to the subwoofer section somewhere.

Actually, just not connecting the power cord may disable the subwoofer section and that is all you will have to do.

wink.gif

A good external powered subwoofer will almost certainly provide better low bass, so it is an improvement that is a good idea anyway.

I suggest that you consider the NHT B12D subwoofer (which I use), or possibly one of the Rythmic 12-inch subs.
Edited by commsysman - 1/20/13 at 7:34am
Reply
Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Speakers

AVS Top Picks

AVS › AVS Forum › Audio › Speakers › CSW T300 with 2 bad amps