or Connect
AVS › AVS Forum › Audio › DIY Speakers and Subs › LG Clone amp load question (FP10000Q and FP14000)
New Posts  All Forums:Forum Nav:

LG Clone amp load question (FP10000Q and FP14000)

post #1 of 7
Thread Starter 
I was just wondering if anyone has run either amp on a 2 ohm load.

I know it's not recommended but was just wondering if anyone tried it.

thanks in advance


PS.
I'm running my FP10000Q in bridge mode with a 8 ohm load per channel and the amp barely gets hot and this while blasting music.
post #2 of 7
How about you try it, Fatshaft? smile.gif
post #3 of 7
Thread Starter 
I can't... eek.gif
I don't think trying it in bridged mode with a 2ohm load is a good idea!
I have 2x 4ohm subs connected per channel, so it's either 8 or 2 ohms for me.

We know that in bridged mode 4 ohms isn't recommended and I would think 2 ohms is insane when bridged!
post #4 of 7
Lol well don't use it bridged then. wink.gif
post #5 of 7
Thread Starter 
Quote:
Originally Posted by Scott Simonian View Post

Lol well don't use it bridged then. wink.gif

OK then...rolleyes.gif
post #6 of 7
Nobody has had the balls to try it so .... grab the torch! biggrin.gif
post #7 of 7
Do it. DO IT. wink.gif
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: DIY Speakers and Subs
AVS › AVS Forum › Audio › DIY Speakers and Subs › LG Clone amp load question (FP10000Q and FP14000)