or Connect
AVS › AVS Forum › Blu-ray & HD DVD › Blu-ray Players › No video from receiver after installing new Sony BPDS-185/BX18 Blu Ray
New Posts  All Forums:Forum Nav:

No video from receiver after installing new Sony BPDS-185/BX18 Blu Ray

post #1 of 3
Thread Starter 
Just purchased Blu Ray Player (Sony BPDS-185/BX18) and plugged HDMI out to receiver ( Yamaha HTR5990) and have to use component to my projector which requires over 30ft so I use RGB but I do not get video . So , I ran the composite to my receiver from the Blu Ray and now I get both sound and video but picture isnt good.. I want both so should I run an HDMI cable from the Blu ray to the Yamaha in and a 35FT HDMI out to the projector ? Will I then get video from the projector and sound from my receiver? Or is there a better solution? Like , I could move the Blu ray closer to the projector and run a 6ft HDMI cable to the projector and then the 35ft RCA cables out of the projector to the HTR 5990 . Would that be the best ? Or?
post #2 of 3
Mods ask that all posts/questions go in the official thread for the player. Setup will be there.

http://www.avsforum.com/t/1385000/sony-bdp-s185-bdp-bx18-blu-ray-disc-player

Component on current players will not support HD video per the analog sunset:

http://www.avsforum.com/t/1305969/analog-sunset-begins

S~
post #3 of 3
Not much good posting in a player thread: it is a receiver issue. Nothing to do with analog sunset either if player does not have component video output.

Receivers do NOT output component video from HDMI input. If projector has HDMI then use HDMI out from receiver. That's how most people do it.
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Blu-ray Players
AVS › AVS Forum › Blu-ray & HD DVD › Blu-ray Players › No video from receiver after installing new Sony BPDS-185/BX18 Blu Ray