Hello there,
I have recently acquired a second hand Seleco 350 CRT projector.
It was originally set to a ceiling front projection and I wish to use it as a desktop projector.
Now... I've entered installation mode and changed the installation type from 'Ceiling front'
to 'Desktop front' and saved it as such. When I choose this option the image stretches a
little but other than there is no change - the image is still upside down.
When I switch the projector on and off again it is still saved as 'desktop front' and says so on
the information screen.
Any help/advice for this would be much appreciated as the picture quality is great otherwise...
and my neck is really starting to hurt!!!
I'm quite new to this so am assuming I have missed something very simple.
Thank you!!!!
Dan
I have recently acquired a second hand Seleco 350 CRT projector.
It was originally set to a ceiling front projection and I wish to use it as a desktop projector.
Now... I've entered installation mode and changed the installation type from 'Ceiling front'
to 'Desktop front' and saved it as such. When I choose this option the image stretches a
little but other than there is no change - the image is still upside down.
When I switch the projector on and off again it is still saved as 'desktop front' and says so on
the information screen.
Any help/advice for this would be much appreciated as the picture quality is great otherwise...
and my neck is really starting to hurt!!!
I'm quite new to this so am assuming I have missed something very simple.
Thank you!!!!
Dan
