Best Picture quality cable for 3D projector

Installing a Epson 5020 ( just waiting on screen).

Question is what is my Best option for BEST picture quality. My install guy is telling me to run Cat6 from my Denon 2313ci. I have been reading up on HDMI with redmere chip technology.

My thoughts are that with cat6 I need to convert the signal basically twice. Once for the AVR and once for the PJ. Sticking with redmere HDMI that's not an issue. I need to run about 30-40 ft

I'm interested in BEST picture quality, price is not the concern.

Thanks!!!

Good point Neurorad.

Drop kick, that cable sounds amazing. Seems like its design is more for much longer distance though. Is it going to improve my picture over 30-40 ft?

I like neurorad's advice. I am going to suggest the redmere cables to my installer and see what he says.

After doing a little more research it sounds as if the CAT6 setup will be less susceptible to handshake issues and will last alot longer than an HDMI cable. I have 4 corners (bends) to make, apparently this also causes issues with HDMI cables.

On the other hand my set up is not going to be hard to replace a cable if it goes won't handshake, etc. The redmere 40- 50 ft cables cost 1/3 what the cat6 install is going to cost.

I know I said that price was not a concern, but that was to get the best quality picture. After some advice and reading up it sounds like the picture quality will be the same no matter which option I go with.

I took your advice and asked my installer about using redmere. He didn't know what a redmere HDMI cable is. We are in a small town that has a couple of big box stores and him so not a lot of competition. Regardless he says he won't install any HDMI that needs more than 30 ft. As you said he will stand behind his install. To me that's worth the extra $120 right there!

Thanks all for the help!!

Thanks Joe. Sounds like your Plan A is the same as my guys plan. Actual cable run is going to be 36' plus any needed slack.