Originally Posted by cookieattk
so i got to test one of these clones here are results on a 30a 220v line.
also these amps clip Well before the lights even get close to indicating so.
bypassed all the fuses they blew too easily.
so peak should be double these numbers
2600w / 2x ,4ohm load 10hz, thermal limit 3s, pulling 7.6k watts from wall
1600w / 2x ,8ohm load 10hz, thermal limit 15s, pulling 5.4k watts from wall
5580w / 1x, 4.6ohm, thermal limit 3s, 8.5k watts from wall
4050w / 1x 8.2ohm , thermal limit 8s, 6.9k watts from wall
things to note, this amp is class H.
i was expecting a little more power out of it RMS
it has no roll off till 6hz .
it didn't die while i was testing it.
thd was 1% at the numbers above as i said Clip Lights Are not accurate in any way on mine.
u cant get these numbers with the stock fuses installed they blow at about 4k watts.
so pretty good amp if it wasn't for the reliability.
i would still buy a ipr2-7500, sorry but 5 year warranty is just worth it it also uses 25- 30% less power then the clones do at same power.
if your pushing these hard i would replace the stock power cord mine got very hot didn't seem to be under gauge some type of Chinese trickery going on inside that wire.