Originally Posted by nickle2 Problems Common To The iView & The HmWrx STB's
If you are asking about the issue where the HDMI output has anything to do with the "No Signal" messages, then you might ask over on the HmWrx thread. I'm sure there are many more users over there that can comment on their experiences with the HmWrx box. To be very honest.... I did not run the HmWrx firmware very long mainly because iView came out with their last version and I was anxious to try that out.
I can tell you this though..... when I was running the HmWrx firmware I did experience some of the same system instability problems. This leads me to believe that all is not, or can not be corrected via firmware.
For "No Signal", I see this issue on V7 only. Current V3, I don't see this issue.
To me both HmWrx 150 and IV3500 is pretty much the same stability. May have difference issue
For HmWrx150, I have not seen "No signal". Occasionally when playback record program, It will hung at certain point, have to power down
and power up to reset. When play back to that hung point, will hung again, have to fast foward pass hung point and will continue play normal.
Another issue, if you hit too many key in the remote before waiting for the currect one finish. Will also hung it. Have to do power down and power up.
Both IV3500 and HmWrx 150 have mischief behavior. I read through other DVR forum, look like everyone has some type of this miner issue or not perfect issue. 99% Daily/weekly recording is working.Edited by png5 - 9/5/13 at 7:29am