You guys are busting out the hardcore questions today ;-)
Originally Posted by tomcrown1
Ian on the quick start guide Gefen tv which is the correct name list the model #GTV-HDMI1.3-441N. On their site they list it as 4X1 switcher for HDMI with RS232. I have used the model#GTV-HDMI1.3.441 with no result.
On Gefen support forum someone stated that they sent the Hex code to Harmony customer service and 1-3 switch works while switch 4 reverts back to switch 1. Gefen does list the hex code on their site.
I was able to get the gefen to work with the harmony one.
Tom - you were correct in your PM. Myharmony doesn't learn RAW IR commands, it always tries to match against a known IR protocol. The old Harmony software did allow to learn RAW IR. There are some complicated instructions I could give you to get your switch working using the RAW commands you already learned, but I hope I can get this fixed on our end within a day or two. Stay tuned...
Originally Posted by jnnt29
Yes I am, sorry for the confusion. I have aready created the new activity and will synch it to the remote when I get home. I have a follow up question, if I want to have the watch TV activity in the main theater and listen to music on the second zone, will this turnoff the main theater when i launch the zone 2 activity? I think it will or is there a way to run two activities at the same time?
JT - As mdavej points out, our activities concept isn't really intended for what you want to to, but it is possible. Try this:
Set all of the devices used in both your TV and Music activities to "leave on between activities". You can access this in Devices > Change Device Settings > Power Settings. This way, when you switch between TV and Music activities on your remote, all the devices in the 'other'' activity will remain on. The downside to this is these devices will always remain on even if you switch to a different activity. This may
Alternately, your TV and Music activities could each include all the devices in the other activity. Again, when switching between activities everything would stay on since the remote thinks they're part of the activity. The bigger downside here is, if you really are JUST watching TV, the devices in the other room would turn on automatically all the time. I recommend the first option above to avoid this.
Originally Posted by vagos1103gr1
When I run the activity watch movie that this is open the projector when I want to close the projector it needs 2 times the power off on my pj. How I do it this with the harmony?
Vagos - log into your account and go to Devices > Change Device Settings > Power Settings > I want to turn this device off when not in use > I press two different buttons for on and off. In the list that appears, choose the "Power off Commands" option at the bottom of the list. Click the "+ Add Command" button at the top of the list and add an additional Power Off command. You may need to insert a delay between the two commands or specify a duration for which to hold each command.
Hope this helps guys.