So I tried getting an answer to this in the remote forum, but I'm not getting any response. I've read a few threads that talk about this topic, but they aren't very specific. Everyone says you set your lighting zones how you want them, then just hold down the scene button and it will automatically program the dimmers. I need specifics. I've tried this and the dimmers don't program, they just start reacting as if I'm telling them to go to a particular scene, which they can pre-programmed with some default settings. I have a Harmony 700, and I set it up such that when I go to device mode and select my lighting device.....I have just a few buttons: All on, All off, Dim, Brighten, Scene 1, Scene 2, Scene 3, and Scene 4. When I set my 4 zones how I want them for a particular scene and hold that scene button, the lighting just changes to the default command. Do I have to program these scene buttons as soft buttons in the number pad (i.e. scene 1 = "1" on the number pad)?
post #1 of 5
5/21/13 at 2:10pm