or Connect
AVS › AVS Forum › Display Devices › Digital Hi-End Projectors - $3,000+ USD MSRP › 3D transmitter instalation (Mitsubishi HC5)
New Posts  All Forums:Forum Nav:

3D transmitter instalation (Mitsubishi HC5)

post #1 of 3
Thread Starter 
Hi guys,

I have bought one of those units for a bombastic price of 1600€, i like it very much in 2D because i did not tested yet in 3D.

I have a question that maybe is too noob smile.gif where should i install the 3d Transmitter, in the Projector itself or in front of the audience seats?

Because i dont know how these tranmitters works. I am speaking about the original Mitsubishi Transmitter.

thanks,
morg

Gear mentioned in this thread:

post #2 of 3
The emitter can be placed at either the projector or by the screen. The signal is strong enough to be placed at the projector, bounce off the screen, and then be received by the glasses. Placement shouldn't make too much of a difference.
post #3 of 3
Thread Starter 
I have tested it today using the projector on a top table, and used the transmitter near the projector but it did not sync eith the glasses because the projection was 3d , the BR is 3d capable, i can watch the 3d movie but the glasses are not working properly.there ismeantoactivatethetransmitter or its automatically when connected.
I have also tested tested the glasses and they are working accordingly to the manual. When i look inside the transmitter ican see the green led, that means the transmitter is working, so i am out of clues here.
Any suggestion.

Thanks,
Morg
New Posts  All Forums:Forum Nav:
  Return Home

Gear mentioned in this thread:

AVS › AVS Forum › Display Devices › Digital Hi-End Projectors - $3,000+ USD MSRP › 3D transmitter instalation (Mitsubishi HC5)