AVS Forum banner

Onkyo TX-NR818 Zone2/3 issues

1K views 2 replies 3 participants last post by  jdsmoothie 
#1 ·
Hello, just purchased the Onkyo TX-NR818 receiver, and am trying to find a solution for getting TV sound out of Zone2/3.

I have my theater room hooked up and can get sound from 7.2.

I have a 2nd TV hooked up to the 2nd HDMI out on the back of the receiver, turn on Zone2/3 amp, and get nothing for sound.

Have read that Zone2/3 will not do digital only analog with this model.

Any thoughts would be helpful.

Thank you.
 
#3 ·

Quote:
Originally Posted by raj71  /t/1519573/onkyo-tx-nr818-zone2-3-issues/0_100#post_24401430


Hello, just purchased the Onkyo TX-NR818 receiver, and am trying to find a solution for getting TV sound out of Zone2/3.

I have my theater room hooked up and can get sound from 7.2.
I have a 2nd TV hooked up to the 2nd HDMI out on the back of the receiver, turn on Zone2/3 amp, and get nothing for sound.
Have read that Zone2/3 will not do digital only analog with this model.

Any thoughts would be helpful.

Thank you.

1. To pass audio to the TV via one of the HDMI outputs, the Audio TV Out (p. 75 OM) must be set to ON, which will then mute the surround speakers.

2. The analog only to Zones 2/3 is true for 98% of all AVRs on the market today past or present but refers to the output from either the speaker posts or Zone 2/3 pre-outs.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top