Dave- I built the new 0.8B3 CD and tried to boot it but ran into an old problem with my AVX that Richard is aware of. It is not sensing the 1394 card again. This happens when the AVX is cold. After it warms up in about 3-4 hours it will or should work as it always had in the past.
In the meantime, I researched this thread and did not find any clear cut instructions on the cd burning process. Mostly it's YOYO procedure. You did state the process in very brief description but it was in two different posts thread page apart.
Anyway, I read where others were getting error reports and didn't see any response to them. Guess? this is normal.
Stop in module UPD3B_GI at address 055F:01B6
Not sure why and not sure why it was different address than what others reported but that is what I got.
The new CD booted fine but generated an error when trying to sense the OHCI PCI card. FWIW- the original cd's I have stop at the same point. As I said, I'll let the AVX box warm up and soon it should sense and finish the boot up as it has done in the past.
I have had the AVX off since March and that is why it has coold down to RT.
Phire- I recommend you get a card reader for dumping the pics off. I use a PCI card for my notebook in the field and a USB reader at home. Cost $14 ea. Cheap! This is my 3rd digital camera in 6 years. My otherone got smashed in my luggage on the flight home from NAB. Good excuse to upgrade.