Stewart screen problem

Subscribe Search This Thread

Start a New Thread

post #1 of 3

11/9/00 at 1:00pm

Thread Starter

1,023 Posts. Joined 8/2000
Location: Singapore
Thumbs Up: 10
Select All Posts By This User

I just received my new Stewart Luxus A Electriscreen.

I was disappointed to see that the power/control cable for the unit is truncated bare wires (no plug, etc). I naively thought that I could just hang it up, plug it in and go. I guess I need to buy a power cable and splice the wires or something? Any tips/info?

Thanks,
Bryan

post #2 of 3

11/9/00 at 3:50pm

1,288 Posts. Joined 6/1999
Location: Oak Hill, VA, USA
Thumbs Up: 10
Select All Posts By This User

Bryan,

Why don't you contact the manufacturer and ask them what procedure to use? Don Stewart comes to this forum from time to time but you'd be better served if you used proper channels and contacted customer service. Good luck with your new screen.

post #3 of 3

11/12/00 at 2:39am

639 Posts. Joined 9/2000
Location: Tempe, AZ
Thumbs Up: 10
Select All Posts By This User

Bryan,

I'm sure that over 90% of the screens that Stewart sells are not installed by the customer. We usually have to extend the wire that Stewart gives us to plug the motorized screens in, so we always expect to have the proper parts on hand.

To answer your question, yes, you will just need to goto Home Depot and buy a 110v 2 (or 3?) prong plug. Sometimes we run the power pretty far so that we can switch it on with the receiver or projector. (When a 12v ground is not availible)

Dan

------------------
Dan Henderson
dan@net-impress.com

Start a New Thread

Subscribe Search This Thread

New Posts All Forums:Forum Nav: