Ok so I just laid out over a $1500 for 6 Buttkicker advance units, a behreinger EPX4000 amp and spent 2 weeks designing and bolting these things to my 6 recliners only to have the BIGGEST letdown ever last night...I couldnt get these things to work at all i switched stuff around for 3 hours and finally gave up!!!! I checked all the + and - connections everything looked fine.Equipment:
Receiver Yamaha Aventage 3010
Berhinger EPX 4000
6 Buttkicker advance units connected in 2 series (2 rows of 3 recliners)
I have attached a diagram of my setup...(crude diagram)
Subwoofer 1 goes to a regular subwoofer
Ok so I connected the subwoofer 2 output of my Yamaha receiver into a Y-Splitter which then feeds 2 rca wires into the EPX4000 amp.
I then have 2 rows of 3 Buttkickers wired in series.
Each of these rows feeds 1 channel on the EPX4000 amp.
The setting on my receiver for the subwoofer 2 are in-phase and at 1.0 db, when I run a test tone setup everything runs fine to my regular subwoofer but my kickers dont do anything, i've adjusted the db from highest to lowest on both the receiver and amp, i dont know what to do next any ideas or help would be much appreciated.