Originally Posted by bibe2146
Thank you Bob for the advise.
I had problem with the output HDMI after several week the upgrade to the release 1.33.
When I play with my DVD on the screen I saw a white line around the actor or some object on the HDTV.
Last week the HDMI ouput stop working but my HDMI input work fine because I send back to the component output.
I tried to change my cable nothing same issue.
I tried my DVD plug direct to my HDTV work fine.
While viewing the DVD, bring up the Video Source Adjust menu (press and hold the "7" key on the remote). In the Picture panel, check that you have not accidentally turned on the Detail Enhancement option. If it is turned on too high it will produce "halos" around edges.
Your HDMI output problem could be a lot of things.
First, go into the Setup > Video Output menu (use the Front Panel display if you need to) and change the output resolution temporarily to 480p (or 576p in Europe). This is the "simplest" resolution for HDMI.
Check your other settings in there as well.
Then go to the Setup > Source Setup menu for a source and make sure the correct Video Output Configuration is selected (you have 4 configurations you can define).
If you've got video now, then go back and re-enter the correct output resolution and try that again.
If you are still not getting video, give Anthem tech support a call.
Keep in mind that the on-screen volume display, the on-screen Setup menu, and the on-screen Video Source Adjust menu are all produced internally in the Anthem -- independent of any source device. So you can use them to find out if your output is working at all and then focus on the output side or the input side of the Anthem according to what happens.