AVS › AVS Forum › Display Devices › LCD Flat Panel Displays › Sharp Aquos 46d62u Service Menu
New Posts  All Forums:Forum Nav:

Sharp Aquos 46d62u Service Menu

post #1 of 5
12/12/06 at 1:10am
Thread Starter 
Hey, I tried posting this in the settings and tweaks thread, but no one replied. When I try to get into the service menu on the Sharp Aquos 46d62u it doesn't work. Now you are supposed to hold volume down + input while the tv is unplugged then plug it in while doing this and a K in a box should pop up on the left side of the screen. From there you are supposed to hold volume down and channel down and the menu will open. But when I hold volume down and channel down nothing happens, what am I doing wrong here?
Reply
Reply

AVS Top Picks

post #2 of 5
12/12/06 at 1:14am
Unplug TV.
Hold down Vol- and Input on the panel (not the remote), plug TV in
Wait until K shows up
Release Vol- and Input
Press Vol- and Ch<<br /> Service menu should show up.

Be careful, don't mess things up.
Reply
Reply
post #3 of 5
12/12/06 at 6:56am
The TV must be ON when you unplug the power cable.

.
Reply
Reply
post #4 of 5
1/3/07 at 6:09am
Can you get the number of hours a Sharp panel has been on for in the service menu?
Reply
Reply
post #5 of 5
3/21/11 at 8:51pm
Hi all! This is my first post on this forum, so be gentle with me :-)
Anyway, I had trouble getting to the service menu on my D62U as well. I followed all the directions just fine. I did get the "k" on the screen, but pressing and holding the Vol(-) and Ch(-) buttons didn't bring up the service menu (at first). Then I wondered if it was because I was getting a signal on my HDMI port. So, I turned off my AV tuner (routes all my signals) and tried again. Voila! I did indeed see the service menu. I just thought I'd share this with everyone else who had this problem.
Reply
Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: LCD Flat Panel Displays

AVS Top Picks

AVS › AVS Forum › Display Devices › LCD Flat Panel Displays › Sharp Aquos 46d62u Service Menu