or Connect
AVS › AVS Forum › Display Devices › CRT Projectors › Component Input Card for Marquee?
New Posts  All Forums:Forum Nav:

Component Input Card for Marquee?

post #1 of 9
Thread Starter 
Guys!

I have not followed this closely, who has the best one? It would likely get fed from a Toshiba HD player.
post #2 of 9
The only one i know of is the one Moome makes, the older DVI modle has component also and the new card comming out will also have component. And i know VDC has a HD modual for the marquee but not sure what that is i have sent e-mails to them asking but havent gotten a responce.

Athansios
post #3 of 9
Thread Starter 
Quote:
Originally Posted by nashou66 View Post

The only one i know of is the one Moome makes, the older DVI modle has component also and the new card comming out will also have component. And i know VDC has a HD modual for the marquee but not sure what that is i have sent e-mails to them asking but havent gotten a responce.

Athansios

The Electrohome HD board is RGB and tri-level sync for a few broadcast tape machines and is likely obsolete at this point.
post #4 of 9
Yep, your only choice is Moome's board or getting a transcoder like Kim's.
post #5 of 9
Thread Starter 
Hello

Which one had power issues if installed wrong? Will component go over a 25 foot cable run OK?
post #6 of 9
I used component at 25 feet to a digital before i went crt and that worked fine.

Atanasios
post #7 of 9
Just make sure the 3 wires comprising the component run are all the same length.
post #8 of 9
I have Moome's original DVI / component card with 25' component cable and it works fine. My Blu ray will only allow 720p over component, so I output 1080p via HDMI>DVI. (cables are blue jeans)

Moome's new card, HDMI / component is due out in a couple of weeks and has optional gamma control and an optional remote. (HDMI 1.2)
post #9 of 9
Quote:
Originally Posted by Jim Kildare View Post

Moome's new card, HDMI / component is due out in a couple of weeks and has optional gamma control and an optional remote. (HDMI 1.2)

couple of weeks? It's been due out now for 3 months I love his card but there's a serious supply problem with his stuff.
Tim, Dave Babbit has one on his 8500 if you want to check it out. He's moved from Bell Road down to Surprise but the loop should get you there in 30 minutes. It looked pretty good to me with a DVI cable feeding HDTV but I thought up-scaled RGB from HTPC looked a little better. This was with the old Moome card, the new one is supposed to have a better chip and be able to take HDMI directly.
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: CRT Projectors
AVS › AVS Forum › Display Devices › CRT Projectors › Component Input Card for Marquee?