Rythmik Salk dual subs
Seriously thinking about a Rythmik F12G with Salk cabinetry to match an existing Linn Sizmik 12.45. Jim Salk confirmed he can easily match both finish and size. Question I have is the possibility of adding the F12G as a second sub now and at some point due to a failure (Sizmik failed 2x but I was able to get it working) or selling, I will add the second F12G. Would this be possible to get decent results at least temporarily or would it be a waste of time?
Open floor plan and vaulted ceilings in a living area that doubles as a listening room. Room is 30’ long x 14th wide with 8-15’ vaulted ceiling. Seating is about 13th’ from the front, center and sub speakers currently. Open to a fairly large kitchen and small foyer.
System has Anthem D2V (ARC), Linn 4200 amps aktiv, Espek, Ekwal and Katan speakers.
Sizmik Spec from Linn:
Pitch accurate bass reinforcement
loudspeaker with integral active amplification and equalisation circuitry for stand-alone use Audio and A/V bass reinforcement
47 litre, braced MDF cabinet with separate cavity for power amplifier module
12 inch, paper cone, long throw bass driver 9Hz- 220Hz
Signal sensing, auto on/off
4 step internal low pass frequency
@ 50, 80, 120Hz and flat
9 step internal high pass frequency
from 9 @ 220Hz
9 step external high pass frequency
from 9 @ 220Hz
Adjustable gain, 35dB in 1dB steps
3 step bass equalisation
Absolute phase: true or inverted
4 step time out after signal loss @ 5, 10
and 20 seconds or on continuously
Fully protected against overload, over temperature, full short circuit and overdrive 500 Watts
Line level audio in and loop out- RCA phono Line level high pass output- RCA phono
High level- 4mm input connectors
American Cherry, Maple, Black Ash H450mmxW420mmxD435mm
H 17.7 inches x W 16.5 inches x D 17.1 inches 27.6 kg/60.8 lbs
Last edited by doubleroll; 03-28-2020 at 06:11 PM.