Quad HS-24 Ported build
I was recently asked to design and build four ported cabinets for some HS-24s that are being purchased in the Black Friday sale. The only problem, I have to finish them the weekend after Thanksgiving!!!!This is the progress from week one. Tonight I should be able to glue on the baffle and get started on number 2 and 3 Saturday. I spent a lot of the week building a giant out feed table for the table saw that will allow me to cut a full sheet of MDF. It takes a few minutes to setup, but it makes the job sooooooo much easier. I'll post the specs later. They're around 19ft^3 tuned to 17-18ish Hz. I'm sure the proud owner of these bad boys will weigh in soon enough on the thread. Needless to say, his custom theater is going to be incredible.
JVC RS-540, Sony UBP-X800, Onkyo TX-RZ730 (7.2.4), Onkyo M-5010, Elite Screens 100" 16:9 (Spandex AT DIY)
DIYSG Fusion-10 LCR, DIYSG HT-8 surround & SB, Polk TSX-150C (DIY) Atmos
Triple HS-24 mkiii 11cuft sealed, Behringer NU-12000, Crown XLS-2502, MINIDSP 2X4