That's what cabinet makers would call a 'racked cabinet' and can happen if parts aren't glued up square and flush. It mostly happens if your rear panel isn't kept flat as you glue parts to it. If you haven't glued the front baffle on you can fix it.
Looking at the pictures you posted: Take a long clamp going from the top of the cabinet to the bottom of the cabinet and put the pad of the clamp half way on the baffle section that is sticking out, and halfway on the panel it needs to flush up with. As you tighten the clamp it will pull those pieces together. If you do that on the right and left side of the cabinet, it will square it up. After you do that to make sure it works okay, unclamp, add glue, then reclamp to square up the cabinet and obviously lightly clamp the baffle on from front to back as well.
If that's not easy to understand, I'll try to draw some pictures or explain it with more detail.
Okay got the to big claps going to attempt to fix this
Sent from my iPhone using Tapatalk
I have a little overhang on one side now not to bad much better then before but I can your a bit trim router bit to make it even and take that off
Last edited by frankie2075; 11-25-2019 at 02:20 PM.