Hello I will do finally POT tuning with manipulation assistance of my friend, and without scope, with TV turned Off. What I am certain I will mark original POT position, then I will try to go fully clockwise with Set UP and Set Down, and will go 1h in clocks down from max clockwise position. I expect pixel missfires, if happend so again opening of TV
then Set up in the middle , between original postion and max counterclockwise position and I`ll check. If Picture is too grainy Set Down is too maxed.. so little down again
I won`t sure get max blacks but I`ll check if no pixel missfires and if its better in 2d , 3d movies in bright and dark scenes and after cold start. Maybe I would be able to do it tomorrow or day after, depends on mines friend free time. Disassembly assembly will be for me tricky , I put TV on table faced down , table will be folded with 2 thick blankets (2layers) to make cushioning
anddd backpanel is burried deep inside bezel so some screwdriver is necessary to pull it out after screws are taken out ?
I think so. Anyhow gloves are prepared to not cut me and my friend Tv backpanel is sharp and bezel as well. I will put down screws exactly on places how I will take them out to easy know where to put them again
it was recommended very helpfull. Any issues of dissasembly assembly warning are welcomed, dust can come easy to set when you are not carefull and so on. Stand shouldn`t be issue to apply in after backcover is put again on tv right ? Stand can be put in when TV is faced down on table and on the edge of table you simple put stand inside TVand apply screws right?
Thanks for crossed fingers, even 30-50% improvement of deepest black is maybe too much expected , we`ll see.