AVS Forum banner

Consolidated Kuro Programs

4K views 1 reply 2 participants last post by  makaveddie81 
#1 ·
I'm putting makaveddie's threads in one location since it's easier to locate this way. And for possible future use for me.

Kuro Kapture https://www.avsforum.com/forum/167-plasma-flat-panel-displays/3026294-kuro-kapture-program.html

Kuro Tables https://www.avsforum.com/forum/167-plasma-flat-panel-displays/3026300-kuro-tables-program.html

Kuro Command https://www.avsforum.com/forum/167-plasma-flat-panel-displays/3026292-kuro-command-program.html

KuroCal https://www.avsforum.com/forum/167-plasma-flat-panel-displays/3026296-kurocal-program.html

If i already have access to the service menu with a remote, do i still need to get the software to change settings? Not talking about voltages as that's already available to change with the remote, other settings?

@makaveddie81 you posted a way to undo a reset before. Can you post that here?
 
#2 ·
These steps perform a back up to allow you to test out a reset and back out of it.

It won't undo resets that were previously performed without this method.

1. access service menu overlay (fay command or fay then facs01 command)
2. go to etc > digital eeprom > delete
3. hold enter button for 5 seconds
4. red led turns on and blue led flashes
5. go to panel information screen
6. dig. eep should say no data! and backup should say adjusted, if not, repeat starting from step 2
7. reset pulse meter
8. exit service menu overlay (fan command or facs00 command)
9. put tv on standby and take it out of standby
10. at this point, you can perform voltage adjustments to correct any artifacts caused by the reset
11. to keep the reset / voltage changes, go to etc > digital eeprom > repair and hold enter button for 5 seconds
12. to undo the reset / voltage changes, go to etc > backup data > transfer and hold enter button for 5 seconds
13. put tv on standby and take it out of standby
 
  • Like
Reactions: saprano
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top