Join Date: Dec 2003
Location: Los Angeles, sunny California
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 10 Post(s)
2x 12" JBL BOSS build - how to connect components?
BOSS builders, chime in please!
In my dedicated HT room I already have two powered subwoofers (both 12", sealed) on duty. But just like many others, I too became inspired by throught's BOSS setup. My back row seats are on top of an 11 " tall plywood riser that can easily accommodate my two 12" GT-X1200 JBL drivers I bought. I don't thing I'll have a problem installing them into the riser sometime next week.
What is unclear though how to power them. My original thought was to somehow connect my Emotiva BasX A-100 stereo (speaker) amp to my Denon AVR-X4400H receiver, but after looking at the back of both equipment I am not sure how to pull that of. (The two coaxial sub out-s are already connected to my two powered subs. I know the LFE signal can be split using a Y connector but would that be the right approach??)
Heck I am not even sure how to hook up the Emotiva amp to the two JBL drivers... Can I use the Emo A-100 at all, considering that it is NOT purpose built subwoofer amp?
Links to view the back plate of both electronics are in next post below.
Last edited by Zzz..oltan!; 07-16-2019 at 03:49 PM.